936 Autodrape® Lift Machines (ADC)
Helps to assure a positive drive and minimize cable slippage. Constructed of coated steel 4″ diameter x 8″ long. Coated wirecenter cable must be used.
EMERGENCY HAND CRANK:
For conversion to hand operation in case of mechanical or power failure.
ROTARY LIMIT SWITCH:
Allows for user defined pre-set stops for the “Full Raise” and “Full Lower” positions. Fully adjustable cam type assembly.
Three-position maintained toggle type. Only one remote control station can be used with this machine, this being wired temporarily to machine at the factory to allow limit switch setting during installation. Magnetic Control System (MCSA) and Low Voltage Control System (LVCS), available as options and allow the use of any number of remote control switches.
Provided by the gear reduction unit only. Provided when switch is moved to center “off” position.
Safety toggle switch which removes power to machine’s internal circuitry.
Power will still be active at the machine terminal strip and on one side of the disconnect switch. To completely remove power from the machine for servicing, power must be shut off at its source and locked out according to OSHA regulations.
OVERLOAD PROTECTIVE BREAKER:
Automatic type helps protect machine, track and curtain against effects of accidental overload. Must be manually reset.
Built into some motors to help prevent possible damage to the motor due to overheating (furnished on some single phase motors only).
1/4 (936), 1/3 (1456), 1/2 (2906), 3/4 (6506)